New Yokomo YZ-4SF2 and YD-2SXIII release

New Yokomo YZ-4SF2 and YD-2SXIII release

29. 5. 2020

Brand new car kits from Yokomo are released. It is new 4WD - Yokomo YZ-4SF2 and 2WD Drift - Yokomo YD-2SXIII. Both car kits will be available in the end of the June 2020. But you can already PRE-ORDER to get car from first batch.

Let's take a closer look!

Yokomo YZ-4SF2 4wd Offroad Car Kit

The YZ-4SF, which has been well reputed by many drivers for its high driving performance, has evolved even further! The bulkhead, motor mount, slipper clutch, etc. have been significantly lightened weight, resulting in dramatically improved movement performances. The base ability has improved by polishing the areas that cannot be reached by setting or driving, and the operability is also improved by setting Ackerman ratio.

Features:
  • Aluminum lightweight front and rear bulkheads
  • Aluminum lightweight motor mount
  • Lightweight slipper unit
  • New designed steering system
  • New design front and rear suspension arms
  • High durability Φ3.5mm inner suspension pin adopted
  • Bush type upper arm pivot (inside)
  • Changeable battery positions
  • Roll center adjustable bush insert rear hub carrier
  • For dirt, and carpet springs / stabilizers are also included

Newly designed front and rear suspension arms improve rigidity. The Φ3.5mm inner suspension pin has also been adopted to greatly improve crash resistance.

Improved throttle response by size reduction of the center slipper provides light acceleration.

Front and rear bulkheads have achieved significant weight reduction. The upper arm has also attached to the shock tower side, achieving both weight reduction and lower center of gravity.


Yokomo YD-2SXIII RWD Drift Car Kit (Graphite Chassis)

The SX series, which enhances traction with a high mount motor, has been redesigned to double deck specifications! Corresponding to high speed driving with a significant improvement in pitching rigidity, quick handling and sharp turning has evolved even further. The front bulkhead is fully loaded with optional parts, such as a one-piece aluminum body, and this is already a competitive kit that responds quickly to severe steering operations.

Features:
  • NEW Aluminum integrated front bulkhead
  • NEW graphite main chassis
  • Graphite upper deck
  • NEWΦ4.8mm Pillow ball specifications (upper arm, tie rod, king pin ball)
  • Standard short Li-po compatible battery holder (New shape)

High-quality finish with plenty of aluminum parts. A highly rigid integral bulkhead improves stability.The shocks are equipped with an aluminum super low friction shock.

Graphite upper deck with significantly improved pitching rigidity. The steering system is a highly evaluated slide rack specification, which draws out neutral characteristics throughout the range of motion.

The newly designed battery holder is designed for low-height batteries. Two types of battery holders are included, and standard size batteries can also be installed.

The rear side inherits the SX series, and the motor mount also comes with a special type of heat sink shape. The motor is rotated in 7 steps around the spur gear shaft, allowing fine adjustment of the weight balance.

Nenechte si ujít

Loading...