Adjust the angle of steering without interrupting the movement of the suspension!
Aluminum knuckle stopper Φ3.0mm / Φ3.5mm for RD-001 ASL Front Knuckle.
RWD drift cars generally use a knuckle stopper (steering stopper) to adjust the maximum turning angle, but when maximizing the turning angle, many people use M3 set screws.
Even with the M3 set screw, the function of the stopper works, but the surface of the screw will hinder the movement of the suspension at the maximum turning angle.
This is where the [Aluminum Knuckle Stopper] comes into play!
Unlike the M3 set screw, the surface has no irregularities, so it does not hinder the movement of the suspension even at the maximum turning angle.
Furthermore, since it is made of lightweight aluminum, it is also effective in reducing weight by replacing it with an iron set screw.
The lineup consists of a Φ3.0mm and Φ3.5mm diameter part.
In addition to Φ3.0mm which realizes the maximum steering angle, Φ3.5mm which is an option when you want to control the steering angle only slightly is prepared.
Φ3.5mm is effective when the commercially available Φ4.0mm has insufficient steering angle and Φ3.0mm has too much angle!
If you are currently using an M3 set screw as a stopper or want to increase the steering angle more than a φ4.0mm stopper, please try it.
|Length from base to tip||16mm|
|Hexagonal hole dimensions||1.5mm across flats|
* Above dimensions are suitable for RD-001 ASL Front Knuckle.
* If you use for the other knuckles, please check the dimensions of the knuckle, wheel before purchasing.